You will need to cut the bottom of the door.
Attic door not flush.
The springs connect to power arms at the upper end of the stairs and keep the door closed and even with the ceiling.
E z hatch attic access door r 50 alternative to attic stair ladder 3 2 out of 5 stars 3 panady attic stairs insulation cover 25 x 54 x 11 class a fireproof attic door insulation cover attic access insulation cover attic stairway insulator attic ladder insulation cover.
The family handyman suggests covering the strike plate with masking tape and smearing lipstick on the latch.
Best access doors suggests installing the ceiling access door flush installation.
Check where the latch on the door hits the strike plate on the frame.
Measure down from the bottom hinge to determine how much you need to trim.
To get that satisfying thunk when a door closes rather than rattles squeaks or scrapes there must be an even gap between the door and the jamb all around.
From loose jambs gaps in the ceiling squeaky springs and cheap hardware to problems with the ladder itself a number of things might need to be constantly maintained.
There are however problems that could arise with attic stairs.
One of the highly recommended products is ceiling and attic access door and panel.
If the door rubs for too long on the carpet it can cause the fibers to break down and leave a permanent swing mark.
When built correctly the stairs are concealed within the attic itself.
I would like to determine what i need to adjust or fix to have them flush with the ceiling when they are closed.
The hinges should be flush with the jamb and move freely.
I have a set of pull down attic stairs that work great except that when they are in the closed position there is an opening of about an inch to and an inch and a half.
We have a service outline that is open for all your calls inquiries anytime.
Don t overestimate how much you need to take off.
When you close the door the lipstick transfers to show if the latch is hitting the strike plate too high too low or just right.
M y ladder won t stay up in the attic.
In the house the only evidence of the stairs is a string dangling down.
Pull down attic stairs have coil springs at each side of the unit.
Mos t likely the assist arm is oriented the wrong way.
When it comes to ceiling and attic installations you need an access door that will not interfere with the surface design or finish.
When the arm is mounted to the attic floor the arm should be pointing away from the ladder and opening.
And the stop and the strike plate should be correctly aligned so the door s latch easily clicks into the hole in the strike plate when the door closes.
